Low built, robust, fabricated from heavy duty steel angles and 8 mm thick plate structure is supported by four heavy duty UHMW material wheels on four corners of trolley. Four guide wheels turning 3600. Two solid steel lifting arms are fitted on both side of trolley which are connected in centre to lifting hydraulic cylinders and hinged with the trolley pillars. Hydraulic cylinder is placed in between two guide wheels in such a way that the load is distributed very well and balancing of trolley can be maintained while transporting from one place to the other. Lifting arms have been fitted with synthetic half round bracket suitable for placing the beam barrel for steady fitting

Special provision to accommodate short and wide working width of bottom beams is provided by shortening and lengthening collapsible device (telescopic type) on the trolley which is operated by manual crank turning provided at the side of the trolley.

One end of the machine is fitted with hydraulic unit & hand pump which is connected to two hydraulic cylinders on both side of trolley.

All the four UHMW wheels are fitted with a pair of ball bearings. All the moving parts which are under load are fitted with suitable sizes of bearings. In all there are seventeen nos. of bearings fitted in the trolley which makes very easy and comfortable movements.


WORKING OPERATIONS

The operator operate the lever of the hydraulic pump at rear side of trolley which lowers or raises the lifting arms to take up or place the beam from sectional warping beaming section or on floor. The trolley can be pulled by one operator on either side of handle bars connected to trolley.